Universal single color mini LED dimmer with RF remote can dim most 5~24VDC LED products from 15%-100% using Pulse Width Modulation (PWM). 8 dynamic color-changing modes with adjustable speed control. Features power cycle mode retention. Maximum load is 4 amps. Attached 4" power input and controller output wire leads. 1 Remote to 1 controller pairing. Range greater than 30ft in open air. Battery for RF remote included.
Product Specifications:
Applications: 聽Brightness and pattern control with adjustable speed and dimming capabilities for accent lighting
Function: 聽Dim and control single color LED products from 15~100% using PWM with RF remote control
Operating Voltage: 聽5~24 Volts DC
Modes: 聽8 Dynamic Modes
Operating Temperature: 聽-30~75掳C
Connection Mode: 聽Common anode (+)
Output Power: 聽48W @ 12V / 96W @ 24V
Maximum Load Current: 聽4 Amps
Control Method: 聽RF Remote Control
Output: 聽1 Channel Single Color
Overall Size: 聽(L)45 x (W)12 x (H)3 mm
Standards and Certifications:
LED Strip Room is a brand you can trust, with years of lighting experience, we invest heavily in quality control and sourcing the best component parts available to us.
As the聽USA's No.1 online LED retailer, at LED Strip Room we pride ourselves on only stocking the highest-quality lighting products, and we are committed to making sure you are聽100% satisfied聽with your purchase. For complete peace of mind, we offer an聽unrivalled five-year warranty聽on all our LED Controller, as well as聽30-day hassle-free returns.
Functions:
Installation:
1. Power Supply
Controller accepts DC 5V to 24V. The red cable should be connected to positive and black cable to negative. Power supply voltage should match that of the LEDs to be used with the controller. For example, a 12VDC LED strip will require a 12VDC output power supply聽
2. LED Output
The red output wire should be connected to LED positive and black wire to LED negative. The peak output current is 12A.
CAUTION!
Do not short circuit the LED output, this may permanently damage the controller!
remote聽
3. Remote Control
Remove plastic tab from battery compartment. Remote uses 3V CR2025 battery, replace only with same type.
Notes:
Only power with 5~24VDC power supply.
Controller can control a maximum of 30 meters of our single color LED Strip. Over 30 meters, the strips have to connect with an amplifier to reinforce the transmission of signal. Use one amplifier for every 30 meters of additional LED Strips.
Do not exceed 80% of Power Supply capacity when calculating Power Supply size to use in your system.
Supply voltage should match operating voltage of led product.
