Universal Red/Green/Blue (RGB) LED WiFi Compatible Controller & Dimmer with hand held RF Touch Color Remote (Requires 2 "AAA" batteries -- Not Included). Can control any 12VDC RGB LED product within range of about 100 feet. Synchronization function allows a single remote to operate one or multiple controllers (User configurable). Color selection wheel provides thousands of color options from pure white mode or 19 dynamic color-changing modes with speed, brightness and ON/OFF controls. Maximum load is 6 amps per channel, 18 amps total. Must be paired with Wi-Fi LED Controller Hub (WIFI-HN -- Sold separately) for adjusting all controller functions using a Smartphone or tablet running Android or iOS using free app 'milight'.
Product Specifications:
Amps: 18.00 Amps
Amps per Channel: 6 Amps/CH
Battery Type: 2 x AAA
DC Jack Type: 5.5 Barrel Connector
Radio Frequency: 2.4 GHZ
Remote[1]: Phone and Tablet (WiFi)
Standards And Certifications: CE/FCC/ROHS Compliant
Suitable for Vehicles: Yes
Type: RGB Controller
Volts: 12~24 VDC
Dimensions: 8.475cm(3.34") x 4.45cm(1.75") x 2.25cm(0.89")
All specifications are subject to change without notice
1. Single Device Pairing allows one control hub and and one remote control to communicate as a unique pair exclusively. Multi Device Pairing allows one remote controller to communicate with multiple control hubs within the required transmitting range.
Standards and Certifications:
Instructions:
Remove strip from reel and make connections to power supply and controller (see 鈥淢ethod 1鈥 diagram). Briefly turn on strip using the included remote controller to ensure proper operation of the strip, power supply, controller, and remote.
Choose your desired yet suitable location for the power supply and controller. For use in dry locations only.
Ensure all installation surfaces are clean and dry.
Begin to remove strip鈥檚 backing while adhering to desired mounting surface. Press firmly to secure strips to surface. Mount controller and power supply to desired location.
RF Touch Color Remote Control:
Controller Pairing锛
The WiFi-SMAT features RF remote to controller device pairing to help eliminate interference from other nearby units. If you wish to control several controller devices from a single RF remote, the controllers first must be re-programmed.
The easiest and fastest way to re-program several controller devices at once is to have them share a power supply or all plug in to a single power strip.
Once programmed you can provide power as you would otherwise, sharing is only needed for the programming phase to ease the process -- Re-programming can be done one device at a time also.
Programming Procedure锛
1. Wire all controller devices to one power supply or power strip but don鈥檛 turn it on yet.
2. With the power off, grab the remote.
3. Turn on the power supply
4. Within 3 seconds of providing power press the 聽button聽
聽button once.
If programming was successful any connected light strips should blink twice slowly and remote will immediately be functional.
Safety:
DO NOT connect controller or strips directly to 120V AC power. This controller requires a 12V or 24V DC power supply.
DO NOT exeec max load of 18 Amps, overloading the controller may cause overheating, shorting, and possibly failure of controller.
Be sure the power supply is not plugged into an outlet before connecting or disconnecting any of the systems components.
DO NOT expose the controller and light strip to direct or indirect moisture.
Always observe proper polarity when connecting power and load.
